Beer Faucet Coupling Gasket Size?

[Conodor]

In the Above Picture it's the D1200B gasket, it's the gasket that goes between the Shank and the Tail. I can't find the size anywhere. trying to save a few bucks since i need to replace 9.

I have searched everywhere, no places seems to want to give the size.

thanks@!

 

[bendavanza]

measure the best one you have and look to http://www.oringsandmore.com/servlet/StoreFront
they have a size chart

 

[Conodor]

unfortunately the 4 i have are installed. I just ordered 5 more faucets but they don't come with the gasket.

 

[wildwest450]

I have an old faucet laying around that looks like that one, the washer was a dead on 7/8". It isn't an o-ring, it is a flat washer. An o-ring may work fine?

 

[Conodor]

thanks the diameter is what i needed. didn't want to take apart my system to figure it out.

i'll post what i order from mcmasters and my results.

I'm thinking that this might be what i try.

208 1/8" 5/8" 11.56 per Pack of 80 Part number 94115k208


http://www.mcmaster.com/?orderview=new#94115k208/=8i8wbo

but looking more at it part number 94115K115 might be a closer fit

http://www.mcmaster.com/?orderview=new#94115k115/=8i9e4j

 

[wildwest450]

The second one should be real close, mine measured a tad over 11/16" inside diameter, but it could be stretched a little from taking it out several times.

 

[Pash91]

thanks the diameter is what i needed. didn't want to take apart my system to figure it out.

i'll post what i order from mcmasters and my results.

I'm thinking that this might be what i try.

208 1/8" 5/8" 11.56 per Pack of 80 Part number 94115k208


http://www.mcmaster.com/?orderview=new#94115k208/=8i8wbo

but looking more at it part number 94115K115 might be a closer fit

http://www.mcmaster.com/?orderview=new#94115k115/=8i9e4j

Did you ever figure out which one this is? I just had to pull a gasket from one of my faucets to install on my stout faucet (the gasket was completely disintegrated). I'd like to have a few as spares