Barley Crusher Manual

[zman]

I lost mine and I am hoping that someone has a .pdf copy they can email me. I emailed BC products last week and have not heard from them.

Thanks,

 

[moonbrew]

I don't know what I did with mine...

Have you got a problem with it?

 

[azscoob]

if you still need it, PM me and I will scan mine and email it to you tonight

 

[BierMuncher]

If memory serves me it went something like:

1) Dump in grains.

2) Turn handle.

I can convert that to a PDF if you like.

 

[bob1852]

Here ya go:

View attachment Barley Crusher Manual.pdf

 

[zman]

If memory serves me it went something like:

1) Dump in grains.

2) Turn handle.

I can convert that to a PDF if you like.

everyone is a smart ass... I want to know how to adjust the rollers and how to take it a part so I can clean it, oil the bushings etc...

 

[bob1852]

everyone is a smart ass... I want to know how to adjust the rollers and how to take it a part so I can clean it, oil the bushings etc...

I apologize - it just seemed to funny

 

[Drunken Monk]

I lost my manual too. I want to open up the gap on mine because I've had a couple of stuck sparges at factory setting. How do I actually turn the knobs to adjust the gap? Do I just latch pliers onto the knobs and turn or do I unscrew something first?

 

[cwilliams108]

I've got the "manual" somewhere in my car I'll look for it and scan it if I find it.

 

[mariojr]

Found this in the photo gallery. It's the Barley Crusher manual.

https://cdn.homebrewtalk.com/gallery/showphoto.php?photo=33143

There may be a more in depth version but I don't know.

 

[Drunken Monk]

That would be awesome!
Hell if you could just tell me how to adjust it that would work too. There's a lot of talk on here about what gap everyone is running but nothing on how to actually adjust the mill.

 

[azscoob]

you just need to loosen the two phillips screws (A) then insert feeler gauge of desired gap between rollers and turn the knurled knobs (B) to adjust the gap down til the rollers contact the feeler gauge firmly, while holding tension on the knob, tighten the screw, repeat on the other side of the mill. (I have two sets of feelers so I set both sides at once)

 

[cwilliams108]

If there is I didn't get it, thats the paper I got with mine.

 

[smccarter]

I apologize - it just seemed to funny

It really did. I laughed. Love that you took the time to create a PDF and upload it. Very funny stuff.