• Please visit and share your knowledge at our sister communities:
  • If you have not, please join our official Homebrewing Facebook Group!

    Homebrewing Facebook Group

3D Printed Tap Handles

Homebrew Talk

Help Support Homebrew Talk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Hey there Jaybird! Long time, no talk..Check out post #331 in this thread for some photos of the kegerator during my bar build: https://www.homebrewtalk.com/showthread.php?t=164889

That's a 26 cu ft chest freezer under the tap tower. It holds 12 corny kegs perfectly.. however, I only keep about 4 beers on tap these days. :)

The tap handles are made of ABS plastic and went through an "acetone bath".. 10-30 seconds in acetone steam will do wonders smoothing them out.

Only 12, sure its 26 c/f? I bought a large chest freezer off craigslist that i believe is 22-25 c/f (73" long by forget how wide, outside ofc so lose a few inches inside) but i had calculated i could fit 19-20 ball lock kegs plus 2 on the compressor hump.
 
Back
Top