I apologize if this has been addressed before, couldn't find a direct answer using search.
About to start my build using this diagram:
The only thing I was going to add was an LED indicator lamp to show when the element was actually firing. I was planning on using a 240v LED from Auber.
I was planning on running 2 additional hot lines after the contactor to the LED light.
Do I need to put some kind of fuses or resistors in line to protect the lamps?
Or can I just use smaller wire and go straight to the LED lamps assuming they will only pull the current they need and that the high power won't "blow anything up"?
thanks for any input
About to start my build using this diagram:
The only thing I was going to add was an LED indicator lamp to show when the element was actually firing. I was planning on using a 240v LED from Auber.
I was planning on running 2 additional hot lines after the contactor to the LED light.
Do I need to put some kind of fuses or resistors in line to protect the lamps?
Or can I just use smaller wire and go straight to the LED lamps assuming they will only pull the current they need and that the high power won't "blow anything up"?
thanks for any input