22" of height in kegerator

[Ridire]

Thinking I'm limited to 3 gallon kegs, right?

 

[Ridire]

Hoping to get two beers in there and I'm about 19" deep x 18" wide on the walls (maybe another inch of depth and width if the kegs are under 15" high).

 

[orion7144]

They make these shorties http://www.homebrewing.org/Low-Profile-Ball-Lock-Keg-Short-22_p_796.html that are 22". I have one on the hump of my keezer that holds soda.

 

[Ridire]

They make these shorties http://www.homebrewing.org/Low-Profile-Ball-Lock-Keg-Short-22_p_796.html that are 22". I have one on the hump of my keezer that holds soda.

But leaves me zero clearance for hookup of hoses.

 

[Ridire]

After looking around, I think 2 gallon kegs is the way to go.

 

[orion7144]

But leaves me zero clearance for hookup of hoses.

I have 22" from hump to top of my collar on my keezer

 

[tophmck]

But leaves me zero clearance for hookup of hoses.

That's right. I presume the "low profile" keg linked above is just a pin lock keg that's been converted to ball lock. Here's the same thing on cornykeg:
http://www.cornykeg.com/catalog.asp?prodid=672560

And they list a height of 23-24" once the connectors are attached.

 

[Ridire]

I have 22" from hump to top of my collar on my keezer

Really? So the keg is not really 22"?

 

[Ridire]

Re-measured. I might have 22.25" - 22.33" but that is it.

 

[orion7144]

Re-measured. I might have 22.25" - 22.33" but that is it.

I will measure mine accurately when I get home from work

 

[Ridire]

I will measure mine accurately when I get home from work

Thanks. The 9" diameter should still leave plenty of room to get 2 of those, plus my C02, in there if the height works.

 

[orion7144]

Well it is just over 23" fromthe top of th gas line qith the ball lock connected. Could shave off half an inch with a 90 on the ball lock