I have two RANCO 111000 ETC's one was to control the pump, to circulate the wort through the heat exchanger. the heat exchanger is a 120VAC water heating element in a small picnic cooler. I heat exchanger works well when not wired to the RANCO, when I hooked it up to the ranco it would heat to the desired temp then make rapid clicking noises, I assume from switching on and off, and not turn off.
any suggestions on how to wire these up?
I wired it up like it said in the insert for 120VAC ...
any suggestions on how to wire these up?
I wired it up like it said in the insert for 120VAC ...