Search results

If you can afford a "Diamond" drill, screw the rocks, use the drill bit for the handle!! :drunk:

Yes I have one in the HLT and in the Brew kettle. I usually pre-heat the mash tun so volume in pipes may not matter to much. Today I am going to do calibration testing on pump (rate*time=volume stuff), I like the floating stick idea, however I think I need to have the cap on my sight...

That was just a quick search for this type of device, yes that one is to expensive and I am not sure about it's food grade qualities at high temps. The next big problem with these is the calibration for different temps and types of fluids, (wort, high temp water etc.) would prob change the...

Prob my lack of having a very strict procedure down, I am using a pump but it is a little different pump than a "March" pump. I can pump at any rate/destination/temp or height. I do not have a sight glass in my Cooler so I have a hard time figuring out how much water/grain I have in the mash...

http://www.instrumart.com/Product.aspx?ProductID=22926 Something like this?

I would really like an inline flow meter also. I have sight guages but I SUCK at reading them. If anyone comes up with something I would like to know also.

Great place, had the IPA and a stout. Really nice place.

If I was "smart" I would have gone to GABF too!!!! Well I'll be on my way to SEA, can't wait to see the place.

Going to fly in tomorrow from Texas and stop by for a few, any recommendations?

Does anyone use an in-line flow rate meter?

I use a recycled hair dryer.

I put a shutoff valve, and blow compressed air through system, very little left after that.

+1 This is far easier I did the same!

O, yea (stupid) I guess i was brain dead for a few min, I have a ton of old router/modem/cell phone 6-18 volt DC power supplies. Thanx!!

Will this work with 12volts? To run a 120mm computer fan? I dont need to turn on and off my compressor just need to move some air around in side the cooler.

Thank you guys, never thought about the fact that the compressor slides out and it has its own plug @@. I bought this sucker on Craig’s list, 350$ I took the legs off and bought caster wheels so I can move all of its 400#'s. It is all stainless inside and on top, I was thinking about...

I added this CO2 quick disconnect manifold through the side wall yesterday. I think I need to had some second stage regulators so that I can have different pressures.

I separated the right side out and it is going to be a constant temp, (holds about 54 deg) I want to add a 120mm fan and second controller to be able to adjust. The 2 bays on the left I would like to add the first controller.

OK I have acquired a 3 door behind the bar "Glastender" cooler :rockin: Can anyone give me guidance on what controller I should buy? O, and how to hook it up? Thanx

Yea, I was thinking about the things you posted, I put it into Secondary because I was getting NO activity and the readings were the same for 4 days in a row (prob not long enough), temp is sitting at about 70-72 so I am not sure how much warmer I could run it. I prob did rack to fast and I...