Search results

there's no actual holes except for the rust coming out where the seems are. are there any refrigerator sealants out there i can paint on or Spackle on?

I had an old fridge with a collar that I was using for kegging beer. In my new house i really don't have anywhere to ferment (no basement) and we are moving to a bigger house that I'll have dedicated brew space for as well as a bar!! that's 2 years away. so for now i'll be bottling...

so i have been using my kegorator for my fermentation chamber...i used a blow off and it blew out a bunch of sanitized water to the floor. switched to a vodka air lock after day 4. I went to dryhop today. beer looks fine. krausen on the inside. no white spots. now there is some black...

Do you have a cut list? That's exactly how I want to build mine

Thanks guys! Ill always do 5-6 gallon batches and I have a 1 liter starter. Here she is!

Further I get about a 2" vortex....any higher on the dial and it throws to one end and wiggles there. Any help???

I have everything wired up and it runs fine. Slight vibration but magnet is already glued down. It's based on: https://www.homebrewtalk.com/f51/my-stirplate-cheap-easy-build-86252/ I can't get the magnet not to be throw past a small speed

Thank you so much. LP regulator from brewers hardware is ordered! Ill post pics of it fired up when I get it in!

Going to be totally honest I have no idea what you mean by 11-13" wc???

http://www.agrisupply.com/low-pressure-burner-cast-iron-70000-btus/p/40282/&sid=&eid=/ these are my burners. i don't know the difference between low pressure and high pressure but i have these hooked up. any help would be greatly appreciated on the best way to test my system so i don't blow...

yes i got needle valves on there and those are the smaller burners from Argus not the full 100K burners so i should be ok with the regulator as long as i slowly let in propane thoughts?

as you can see in my pics i hard piped my slotted angle iron with black pipe up to my burners with some shut offs. I used the yellow tape suggested for black pipe. I'm assuming i just put the propane on and close the closest valve and spray with soap water to check for leaks? any other...

Mug, For the gas line do you know where I can find them?

I have a keggle that is converted with a false bottom. There is a quick disconnect attached. When I go to clip in the QD to the pump nothing comes out and that's with the pump off. I can't get the wort down to prime the pump. If the QD isn't on there it comes out the spout no problem. No...

Does anyone know what size labels to use???

Anyone know where to purchase sheild labels? I like the label generators out there but I don't want to print on one big page and have to cut them out. Does anyone know what size i should be getting and where to get it?

does anyone know a good site to order blank lables off of? what size works? I have not labeled yet but this is perfect for what I want to do. Also where can i find the sheild design labels.

Yeah how do you polish kegs??? Don't forget to make sure there are vent holes in your keg bottoms so they don't explode

So i looked all over google and this site for help with a keezer build. BY far this was the easiest one. I credit Billy Brew (just google keezer build). The plug in the middle is for my 3rd tap that did not come with the kit I bought. As for the guts go to beverage factory. Hands down...

So I want to start brewing at my house as opposed to my buddy's. I do not have central AC. I wanted to know any tricks to ferment in my basement that is in the mid to upper 70's without building a fermenting chamber. Thanks!