Recent content by yellow

Have had MM3-2.0 for about 2 years now (only mill I have had) LOVE IT. Mill powered by rigid electric drill. Here is what I do: 1. Condition Grain 2. Dump up to 25lbs in hopper 3. Engage drill - Mills right away, no issues starting or spinning. 4. Marvel at its Awesomeness. 5. Clean...

Wondering if anyone pressure washes their Sanke Fermenters? I thought I was getting them pretty clean by soaking and scrubbing with a brush; however, near the neck where it is hard to see I have ring-around-the-sanke! This was discovered when I cut the bottom off of one to turn it into a bottom...

Govner1 has it down. I have done it in the past and decided against continuing because of the draw back of having to let it settle when moving it. I do have a kegerator, but I also use a jockeybox a lot for family functions. As for over-carbing, just release some pressure and let it reach...

In in in

GOOD FIND! Did not even think of just looking for TEMP DISPLAY. That is definitely a cheap option. Not a huge fan of EBAY even though it would probably save me $. Tried to find the linked temp displays anywhere in the US and it is impossible (with my limited skills). Still leading towards...

Auber Ins was very fast with getting back to me. I had just asked him the same question as the OP. If in AUTO and you switch RTD inputs, the PID will be totally confused. If you are in manual mode switching is no problem (as long as you are not concerned about the calibration of each RTD)...

Equipment: Just starting getting equipment together for e-HERMS. I have my old control panel which has 1 PID. I now have multiple RTD sensors in the system. Problem: How to check temperatures with-out switching or swapping out control panel PID. It looks like a bunch of guys used switches in...

Hell yeah! My reply.

YES! Thank you, had not thought of using both rings. I was stuck on only using the bottom.

Looked but did not find anything. Has any put feet/legs on keggle that is bottom drained. I have seen lots of pictures of brewstands that support the keg. I am looking for anyone that just put legs or feet on the bottom of their keggle so it was free standing. Thanks.

Saw my first shoot yesterday of the 2nd year Cascade and Centennial. They are both potted. Excited to see how they do this year.

EXCELLENT! Thank you for the quick responses....I had seen a bunch of posts about transferring, but it was all PRE-Carbination. Thanks again.

Going on a fishing trip with my step-father and father-in-law and would like to take some beer with. Beer has been sitting undisturbed for weeks and is force carbonated. Can I transfer it to another keg and to make sure it is clear travel ready?

PM on its way

How about THIS(compression 1/2" to 1/4" FNPT) to THIS(1/4"MNPT to 1/4" MFL)