I just tested the ssr with a 12v dc input and everything works fine. I'm not getting any output from my pid. Justvran it up and down and no change in output (stays at 0vdc) even when output lit.
I justvtested it with a light bulb. Pid output indicated, ssr light lit solid light connected from ssr output to nuetral not lit. If i intermintently connect the light to the ssr outlit the light will blink on when first connected but not stay lit.
My red wire goes from the terminal to the input on the ssr. The output from the ssr goes to to the contactor and the output from the contactor goes to the heater element.
This is how i'm wired. Standard 2 phase 5500w setup. If i jumper the red hot around the pid the heater works fine.
If i disconnect the heater from the contactor the pid/ssr part of the circuit appears to work fine as i have the ssr light on when the temp is below the pid setpoint and i get...
Trying to grt my set up runnung and i cant get my ssr to power up my heating element. It is a 240v 5500 heater throug a contactor and ssr controlledbya pid wired from one of pj's wiring diagrams and I can't figure out what is wrong.
Ifi disconnect the heater from the contactoriget the240v phase...
Looking to see if there is any interest in doing this this year.
Although we are still a few months away from being able to dig up rhizomes here in the north east I figured I'g put this out there to get this started.
List what Hop rhizomes you have, what you rhizomes you want (or if you...