Recent content by TBaGZ

12V 10A huh? Does it sound like you have a jet in your keezer?

I am having a hard time finding a PS to run the bulge blower in my keezer. I tried using a couple of old power supplies that I had sitting around, that while they worked, burned out after a few days of constant running. They were both 6v but had low (650ma) amperage. So I bought this 9v 3a one...

The outside of the keezer is stock except for the collar. Nothing is covering the vent, and I have a couple inches clearance around it. I use an STC1000 to control the temp, and I am pretty sure the delay is maxed out at 10 minutes.

I have a GE 7.1 cuft keezer with 4 taps. Since I use pin lock legs I need to put one on the hump, and I am having trouble keeping that keg cold. If I put the temp probe on one of the other kegs the hump keg gets warm. If I put the probe on the hump keg the others will want to freeze. I do also...

It was only three gallons to start with.

Three gallon batch with s04 about three weeks in. Super cloud bomb! Should it start to drop clear soon?

Well I let it soak in the lye water for a couple hours, but I am not sure it did any good. I flushed it and have it soaking in star san for a bit. Nothing came out of the chiller when I was flushing it with water so I guess the previous cleanings did the trick as far as that. Should it have...

I mixed up about two oz to a quart of water and have it soaking.

Going to give it a shot. Guess I need to figure out the "dosage". Can't believe people actually cook with this stuff!

Nothing in a yellow container except Drano Gel. Only thing that says 100% lye is Rowbic crystal. Same stuff? Or they have sulphuric acid.

Thanks

No idea where I would get that.

I really appreciate the time you took to reply and try and help. I will read it in its entirety shortly. I do strap the sensor to my carboy when fermenting, and right now it is on a bucket of water as there is nothing fermenting. Also, my chamber could probably hold 6 carboys. That is most...

Thanks

Would I find that in the plumbing dept with drano, etc.?