Does anyone have a wiring diagram for the Electric Brewing Supply BIAB controller or can take some pics of the inside of the controller?
I have a couple things that I'd like to confirm that the supplied diagram is a little vague on.
I fired mine up today just with water to test for leaks and figure out the controller.
I had to run a auto tune cycle on it to get the controller to bring it up to the set temp. Before the tuning cycle it was only getting within 5 degrees of the set temp and then holding 5 degrees low.
After...
Very tempting but I went ahead and ordered it from brewhardware.com so I can have the switched outlet.
I just need a couple cam lock fittings and I'll be able to get this all setup.
I just got off the phone with someone at Brewhardware a little bit ago and the option with the switch for the alarm outlet should be available Friday-ish.
I was about to buy the RIMS Basic package when I saw on the note that you are considering adding the switch for pump control.
Any idea on when you might have that available?
Also, how is the temp probe dealt with with the RIMS kit since this doesn't use a NPT fitting, Is there a...