Took it apart and reseated the diaphragm. After looking in the end while pushing on the diaphragm, it appears that twisting the knob to the right (tightening it) opens the line letting more gas through.
So after bleeding everything and resetting, I started again with the knob completely out...
Guys, I need help with setting up my Duotight digital in-line regulator since there was no instruction and I haven't been able to find anything specific online.
I recently purchased a Duotight in-line regulator to go in my keezer. I took out the analog guage and replaced it with the digital...
Had the same problem. Move your fermenter as close to your wifi router as possible. I plan on adding another access point in the future so I don't have to continue doing that.
I think I used the suggested template. The only thing I didn't see was the temperature.
angle
58.320
a minute ago
battery
3.940
a minute ago
corr-gravity
1.059
a minute ago
gravity
1.059
a minute ago
gravity-unit
...
No last activity
id
...
No last activity
interval
900.000
a...
Finally got around to making a batch of apfelwein using the new firmware with ubidots. SG and FG were spot on identical to the glass hydrometer readings. Bravo! Definitely recommend it.
Have a 5G batch of caramel apple bochet in my SS Brewbuilt. iSpindel says it has been at 1.015 for about 5 days. Was going to add k-sorbate and k-meta and then keg as I need the conical for next batch. But I have read that mead is an evolving thing that gets better with age if you don't...
Have a 5G batch of Ed's Apfelwein in my SS Brewbuilt. iSpindel says it has been at 1.000 for about 4 days. Was going to add k-sorbate and k-meta and then keg as I need the conical for next batch. But I have read that cider is an evolving thing that gets better with age if you don't stabilize...
Having an issue creating my iSpindel formula. Calibrated it to 89.9 on a level surface, then calibrated it to 23.05 in pure water. Made a wash and dropped it in and it appears that as gravity goes down, the tilt angle does up as in the picture. If 89.9 is horizontal to the wash and the tube...