Recent content by Rossbrau

Great advice! Thanks! Gonna do the best I can in MS paint for a wiring diagram and I'll post it. The CAD programs are terrifying. I'll keep the color coding stuff straight. I'll strip out everything except the switches/LEDs (God I hope those are alright, took me forever) hopefully go with a...

Thanks all for the feedback! I based my setup on this. I never actually sat down and made a wiring diagram (I know, bad idea). I'll definitely take the recommendations for the wiring color changes and make a proper wiring diagram. I'll post that and then just ground up most of the off...

Here's my panel. A closeup of the schematic is at the bottom of the post: Here is the inside of the panel as is currently: Here is a pic of the back of the door. Below is a close up of one of the two boards that control the RGB leds and contact with the switches that control off/auto/on...

I'm at work now, will post pics later tonight. I guess I'm still new to the electronic stuff too.

I already have this board. It has pins for LEDs that I already have wired up. Could I use this?

Alrighty then! If there's active support for it (and it sounds like there is) I'll give it a go. What should I be buying up front to get things started? I checked the buylist, but I have some stuff from brewtroller (relay panel, estop, lcd with icd connect board, icd led displays). What...

Hello wise automated folks! I need your advice and guidance. I have a system all rigged up with a HLT, mash tun, boil kettle, 3 pumps, automated valves, temp sensors etc that was supposed to use brewtroller to function. From reading through the forum way back in the day, it seemed like it was...

Question from an electric-dumb brewer attempting an automated system... Can I run the supply for my motorized valves through cat 5 cable? I'm using the valves on oscsys: https://www.oscsys.com/store/product/291?wwparam=1370178529 Supposedly they should be 12v only using 80 mA, so I don't...