I've been away from brewing and my brewpi for longer than I'd like to admit
But I'm back now
Since I've fired it back up I keep getting an aww snap message from chrome and it says something went wrong while displaying this website
Before that comes up I can see the page for maybe 30...
With the weather hopefully starting to turn I'm starting to think of smoking
Has anyone tried and succeeded in making mods to any of this to run an electric smoker?
Specifically is there a way to get the program to read T.C. Sensors, as I think that is the major roadblock to making smoker...
"and allow for multiple fermentation chamber control without all the fuss you need to go through now. "
But why would you want less hassle and aggravation? I liked fighting with this blasted thing for 4 months.
On my chart it shows different colors on the bottom
For cooling it starts out violet and then changes to blue/purple
For heating it starts out pinkish and then turns red
Are the off colors the waiting periods and the blue red the actual time on or is that indicating...
maybe if I had run the echo -ne 'E\n' > /dev/ttyACM0 command after I did sudo pip install pyserial --upgrade i could have used the web interface to flash the hex
but i did it the other way around so the world may never know
i finally figured this freaking thing out
For inquiring minds I needed to run
$ sudo pip install pyserial --upgrade
For the script to finally start
Tried to load hex with web interface and I got the cannot receive controller number message
Yea I see that fuzze reworked the single instance wiki and hopefully he can get to the multi because something is screwy in Denmark
I did run the pyserial code and was told it was already installed
Really at a loss here. I had this running a few weeks back but the second instance wasn't...