Search results

I've been away from brewing and my brewpi for longer than I'd like to admit But I'm back now Since I've fired it back up I keep getting an aww snap message from chrome and it says something went wrong while displaying this website Before that comes up I can see the page for maybe 30...

With the weather hopefully starting to turn I'm starting to think of smoking Has anyone tried and succeeded in making mods to any of this to run an electric smoker? Specifically is there a way to get the program to read T.C. Sensors, as I think that is the major roadblock to making smoker...

All I can say is thank god you were wearing pants when you took that last picture:ban:

"and allow for multiple fermentation chamber control without all the fuss you need to go through now. " But why would you want less hassle and aggravation? I liked fighting with this blasted thing for 4 months.

Freak out

Woo hoo, the lints are on Cape!

Canadians fan- I'll stick with you

Sometimes?

Hanging in free air, not in line or close to heat or cool source

Just wondering, On my chart it shows different colors on the bottom For cooling it starts out violet and then changes to blue/purple For heating it starts out pinkish and then turns red Are the off colors the waiting periods and the blue red the actual time on or is that indicating...

You could also try $ sudo pip install pyserial --upgrade Worked for me with a different problem, but it can't hurt

maybe if I had run the echo -ne 'E\n' > /dev/ttyACM0 command after I did sudo pip install pyserial --upgrade i could have used the web interface to flash the hex but i did it the other way around so the world may never know

Oh sorry I'm getting confused as to who's who around here

HALLELUJAH HALLELUJAH i finally figured this freaking thing out For inquiring minds I needed to run $ sudo pip install pyserial --upgrade For the script to finally start Tried to load hex with web interface and I got the cannot receive controller number message So I...

Yea I see that fuzze reworked the single instance wiki and hopefully he can get to the multi because something is screwy in Denmark I did run the pyserial code and was told it was already installed Really at a loss here. I had this running a few weeks back but the second instance wasn't...

i tried it said it downloaded i hooked it back up and the script is still not running i tried to start it manually and i got this pi@raspberrypi ~ $ sudo -u brewpi python /home/brewpi/chamber1/brewpi.py Traceback (most recent call last): File "/home/brewpi/chamber1/brewpi.py", line 21...

Yea sorry about that. Thanks for the info. Very few things are working correctly for me on this. I can't for the life of me get either arduino to load the sketch for me Both return the no module named tools errors identical to thyirishmans post just above I hooked both of the...

Day Is this the cron job you have setup for your multi instances or should I be using the cron from your instructions at post 1393? Any help would be appreciated greatly

Anyway you connect the low volt/ control wires is fine. The block connector is only a convenient way to do it. You could use any number of things from stay cons to wire nuts I'm using these http://www.homedepot.com/p/Ideal-Insulation-Displacement-Wire-Connectors-25-Pack-85-925/100192058 You...

I was getting the exact same messages, and tried this solution among every other I could find to no avail I flashed the arduinos with the blink sketch first, the EPROMs clear sketch then the rev c hex using xloader and I'm hoping once I get this reprogrammed it will work Fingers crossed