Recent content by Pintabone

Thanks. I did send them a note so hoping they’ll replace it. It’s literally a hole. I don’t think it’s quite all the way through but it’s more than just cosmetic.

I seem to have an issue with my unitank's coil. I just received it this week and was going through the recommended TSP wash and noticed this on the bottom ring of the coil. It would not wash away and there is what looks and feels like a small hole in it. Any thoughts? I did also reach out to SS...

I think I would much rather go with this approach but like I said, I don't have the room in the garage currently for an upright freezer. Seems like it's not encouraged to carry either the SS 7 gal or CF5 when full.

Yeah, this is really my issue. I could get an upright freezer and put it in my basement but I am currently brewing in my garage. I'd then have to carry the fermenter downstairs which I do currently with a brew bucket. But that's much lighter. So for me I'd likely have to keep the fermenter in...

Do you guys have links to your builds or which did you follow?

For those using a chamber to control temp, has anyone found the smallest fridge or freezer that will fit the CF5 comfortably? I’m looking into getting either the CF5 or the SS 7 gal Unitank and not sure I feel like dealing with a diy glycol unit.

That's promising, at least some activity. Hopefully they'll load the Philly winners then soon.

Anyone know if Philly will finish up today?

Anyone know if Philly completed the judging over the weekend?

I pitched 2 packs of 34/70 without rehydrating at 53 degrees. I've brewed the beer 4 times with consistent results (including BOS out of 300 beers and winning a local brewery's Homebrew competition) so I wouldn't say rehydration is necessary but maybe it would decrease the lag time. I've turned...

I bought a custom 50a panel in November. Received it in December and it's been awesome so far. I would highly recommend Grounded as the price was very reasonable for a custom two element panel. Rex was always responsive to all my questions and follow ups.

Not sure what the prices are of what you are referring to but I picked up a custom kettle from the Spike bargain cave and had them add an extra TC port to it. Wishing now I had them add a 4th port but I'm very happy with the kettle and thought the price was reasonable for the quality.

Thanks guys, I have some leftover pex that I can make a better recirculation manifold out of similar to the SS version. Hopefully that will help distribute a bit better. Does that manifold just kind of float above the grain bed near the top of the wort volume? The grain bed definitely isn't...

Didn't want to quote your entire message but thank you for the long thought out reply. I know the boil off component isn't necessarily tied to the efficiency of extracting the sugars into the kettle. I will adjust my equipment profile to get closer to the boil off rate so that should account for...

Pre boil volume is the same as I manage that through sparging until reaching preboil volume. Post boil is definitely higher as I think I'm not boiling off as much as I throttle down the element power. I know that is impacting the efficiency as the equipment profile still had my old boil off...