Recent content by OBBrewery

Does anyone have a source for long flexible gas lines for natural gas similar to something used for big smoker rigs? I am looking for a 1" hose, that is long enough to temporarily hook up at my gas meter outside on brew days so I can brew in my detached garage about 65' away. I already have...

Thanks guys. Burners were listed at 70k but, so I should be fine with 3/4" pipe. I have a 4' length of 3/4" flex gas line (similar to what you would use for your stove or dryer). The rest is 1" gas line reduced to 3/4". I hook it up about 8 feet away from my gas meter. The boil kettle burner...

Just realized the STC valves are for inert gas. Natural gas is not an inert gas, so I do probably have the wrong valve for this application. Has anyone out there used an ASCO valve for natural gas? If so, which model? Or pointers on how I figure out which to use? Thanks!

Overall setup Gas manifold Closeup of gas manifold at HLT Burner assembly from below Burner from above Link to STC valve product info: https://www.stcvalve.com/Product-Literature/2W160-500.pdf I will only use my system outdoors. I have a 3/4" gas line tapped just after the meter...

Anyone else have any ideas?

This is the 10 jet burner: http://www.bayouclassicdepot.com/products/10-jet-natural-gas-jet-burner-618ng

Thanks BrunDog. There is no regulator except the one on the gas meter. I have my gas line tapped directly off of the house side of the meter so the pressure is whatever my gas meter gives me.

I am building a single tier system similar to Brutus 10. Natural gas system, three 8" jet burners, two of which have gas flow controlled by STC 2W160-3/8 solenoid valves. I hooked up to natural gas and lit the boil kettle burner (no solenoid valve). Works great! I fired the other two...

Great info Kalvaroo. Appreciate the posts. I have the 10 jet burners, can you explain the parts that you used to attach the pilot through the tab in the cast iron ring and to the gas line? What fittings secure it through the pilot light tab in the burner? Thanks! Sent from my iPhone using...