Recent content by JonathanS

Brew Your Own Magazine and Homebrewtalk forum.

thank you for supporting the forum Ss Brewtech! Wish you happy holidays and that your generosity be returned ten-fold. :mug:

I'm in!! :mug::mug::ban::ban::mug::mug: Russian Imperial Stout - All-Grain Recipe Kit

Yes, use the tri-clamp fittings on the bottom of the three legs and add tri-clamp extension tubes to raise the height of the conical above the ground. If I had more vertical space in my upright freezer, I would do the same thing for my brewershardware conical. Still not a terribly hard...

http://www.tejassmokers.com/NatGasHoses.htm Be sure to install a shutoff valve before the flexible hose line and thoroughly test all connections for leaks.

I don't recall; May have had to go to the hardware store to get screws a few mm longer. But the thickness of the walls on the plastic toolbox was minimal.

Home Depot cheap orange plastic toolbox. Plenty of room inside.

Count me in :tank:

That does make sense. I would say that the Tejas Smokers hose is not really that rigid. Look at the dark grey colored hose on their website. I also purchased the quick disconnect with ball valve (item #104023) so when I am done brewing for the day, I disconnect the hose and roll it up on my brew...

I got my NG quick-disconnect line from Tejas Smokers. It was something like a one week lead time, but really a solid built piece of hardware. Holding up after 2+ years of brewing in the garage. I just did a T off the line going to my hot water heater. Also using Blichmann Burners w/ conversion...

Count me in. :rockin:

My freezer is a Frigidaire 13.7 cu. ft. upright. It does indeed fit the 15 gal BH conical, although it is somewhat of a tight fit. I had to cut out material on the door to allow clearance for the butterfly valves. Also, I found it was best to orient the butterfly valves with the handles...

I have had the 15 gallon BrewHardware conical (non-glycol cooled) up to 10psi. I just did a transfer to keg last week using CO2 push. The conical was still fully pressurized the next day when I got around to cleaning it. It might be possible to push it to higher pressure for use as a...

in

I am very happy with the Brewers Hardware 15 gal conical. I did very extensive comparison shopping and thought hard about what features were important to me. However, it does come at a premium $$ and their website says backorded till 4/15. Some of the things I looked very closely during my...