Well it's time for me to part with this system. Making room for other hobbies.
This is a complete brew rig. It's a two-tier 10 gal system with the following features; tippy dump MT with sparge manifold arm and false bottom screen, keg HLT (temp controlled) with three way valve which is...
25' cf chiller using 3/8" copper and rubber hose. Never used. I made it from a leftover roll of copper. Needs to have ends put on it. It'll save you the work of pulling copper though the hose and coiling. $30 + Shipping.
(3) Perlick taps all chrome plated. $50 shipped for all three.
(2) sankey couplers $30 shipped for both.
This is stuff I had lying around that I never used. I would suggest replacing soft goods. Visually they all seem fine and operate. One of the perlicks is a little tight.
msjulian
I know this is reviving a pretty old thread, but I was wondering how your sensor placement worked on the coil exit with the PID controlled HERMS bypass, I made a very similar system and am struggling to get my PID dialed in correctly. I am using it in on-off mode. Would you mind...
Ok I will sent pics as soon as I can get them next week. I did the test with my 3 gpm topsflo pump and the valve wide open, I'm sure if I did it by gravity or throttled the valve that It would have done even better. I think the 3/8" tubing is key, it allows for better heat transfer because you...
I have a 25' CFC with 3/8" copper tube inside a 5/8" hose. If you are interested I'll PM some pictures next week, I will not have access to it until next week. I'm looking to get $70 for it. I am in Lancaster but am also in Middletown a few days a week. I never ran wort through it yet, but...
Hello all,
I am going to use this: http://misolie.com/showshop.asp?id=358 valve for a HERMS bypass loop and plan on controlling it with an Auber SYL-1512A PID in on-off mode. The idea is that by incorporating a bypass loop I can contol the HLT temperature separate from the mash temperature...
I am looking for an orfice for my Honeywell Q314A4586 Pilot light. I misplaced the one that came with the pilot. I need the LP orfice, The pilot come with both one for NG & LP so if you are running NG, you might have one? It would be SKU: 390686-36 from pex supply. I just don't feel like paying...
Hey I am planning a build and am considering using strut for my stand. I am from Ephrata, PA. Where exactly did you get this stuff? I would like to check it out in person.
Nice doing business with you the other day, plan on getting some good use out of the keggle. Your build is looking great keep up the good work. Also, where did you get the clamp rings for your tippy-dump?