All Grain Yeast:
Nottingham Yeast Starter:
Nope Additional Yeast or Yeast Starter:
Nope Batch Size (Gallons):
5.5 Original Gravity:
1.051 Final Gravity:
39 Boiling Time (Minutes):
5 SRM Primary Fermentation (# of Days & Temp):
10 Days at 68 degrees
This is my Haus Pale Ale. A very quaffable beer that is very easy to make using basic ingredients and a dry yeast.
8 lbs. 2-Row Pale Malt
2 lbs. Vienna Malt
0.5 lb. Crystal 10L Malt
Single Infusion mash for 60 minutes at 152 degrees.
I batch sparge in a 10 gallon water cooler with a stainless braid manifold. Click here for great info on Batch Sparging.
Dough-in with 3.5 gallons of water. After 60 minutes, add 5 quarts of 175 degree water and begin vorlauf. My system only takes about 2 quarts before it clears up, then it's wide open to drain in the kettle. Have another 3.25 gallons of 175 degree water ready for the next batch sparge. You should then get 6.5 gallons to your kettle for the boil.
You might be able to do a mini mash with 5 lbs. of light DME.
Heat 3.5 qts of water to ~168/169F in a pot.
Heat a gallon of water to ~170 in another pot.
Add 2lb. of Vienna and 1/2 lb. of Crystal 10L (crushed grains) to the pot with the 168/169F water and stir very throughly.
Put lid on that pot, placed in oven at 150F.
Let it sit for an hour.
Pour the water (now wort) into your brew pot through your strainer. Put grains back into pot.
Pour the 170F water into the pot where your grain is, stir throughly, let sit for 10 mins. Pour that wort into your brew pot through your strainer.
You'll get 50-60% efficiency with that partial mash method.
Add additional water, extract, and hops to the brew pot and proceed like usual.
Here's what I have converted for an Extract version. Vienna must be mashed, but Austin Homebrew sells Munich LME which should bring this pretty darn close to the All Grain version. Just steep your Crystal 10 L and do a full boil and follow the hop schedule.
6.5# Extra Pale LME
1.5# Munich LME
8 oz. Crystal 10L (steep)
Boil & Hops
1.0 oz Cascade 6.6% at 60 min.
0.5 oz. Cascade 6.6% at 30 min.
0.25 oz. Cascade 6.6% at 15 min.
0.25 oz. Cascade 6.6% at 5 min.
Chill to 70 to 75 degrees
Pitch with Nottingham Dry Yeast. No starter or hydration. Update! With the Nottingham shortage, Safale -05 is a great substitute and will make a great beer too. Very similar.
This ferments out very fast, so I will crash cool and keg after 1 week to 10 days. This recipe is calculated at 75% efficiency. I'm getting over 80% though with my Barley Crusher and my 10 gallon Rubbermaid cooler w/stainless braid MLT.
The beer drops very clear after sitting in the kegerator for a week and looks like this.
It's my Haus Ale because it turned out to be a beer that everyone likes. It's light, crisp, dry, and very tasty which means several trips to the tapper.
You can get all the ingredients with a single click here: http://www.brewmasterswarehouse.com