OneHotKarl
Well-Known Member
Hey everyone,
I finally built a cooler mash tun out of the Coleman 70 quart Xtreme cooler and built a manifold. I went with stainless steel because I had some extra parts and now its time to cut some slots in the manifold for draining.
Has anyone figured out a nice size for the slots that works well? And also what spacing works well.
I wouldn't drilling holes instead of slots either, but I don't know which size hole would work.
Any comments or suggestions would be helpful.
Here are some pictures of the cooler with the manifold installed:
(Sorry for the bad quality pictures, they were taken with my laptop.)
http://picasaweb.google.com/snoworshine/Cooler?authkey=hPkF2kPZECc
I finally built a cooler mash tun out of the Coleman 70 quart Xtreme cooler and built a manifold. I went with stainless steel because I had some extra parts and now its time to cut some slots in the manifold for draining.
Has anyone figured out a nice size for the slots that works well? And also what spacing works well.
I wouldn't drilling holes instead of slots either, but I don't know which size hole would work.
Any comments or suggestions would be helpful.
Here are some pictures of the cooler with the manifold installed:
(Sorry for the bad quality pictures, they were taken with my laptop.)
http://picasaweb.google.com/snoworshine/Cooler?authkey=hPkF2kPZECc