yermej
Well-Known Member
Hi, everybody. I'm new here, new to kegging, and pretty new to brewing in general. Received a starter kit for my birthday one year and I've done a couple all extract batches, but it's been a while. I'm moving into a house soon and plan on getting back into brewing, eventually moving to all grain. I'm going to convert one of the Sanyos into a kegerator so I don't have to bottle and I figure the money I'm putting into it will be motivation to get started brewing again.
I was looking into conversion kits, but all the threads I read advocate spending money on the good stuff (Perlicks, all SS, etc.) up front. I'd really appreciate it if you could look over my equipment list and answer a few questions I have about specific items.
I'm picking up the Sanyo SR-4912M from Best Buy today. I'll also be going with a 5# CO2 tank and four ball lock kegs (two in the fridge, two ready to go).
Rest of the parts, followed by a question or two:
- 2 faucet, brushed SS tower from ACU Metal Fab
- Perlick all SS faucets
- SS elbow shanks from micromatic.com (seems to be the only one carrying these)
- 1/4" gas line, 3/16" beer line
- 1/4" flare to barbed fittings & hose clamps
- 1/4" threaded gas & liquid disconnects
- 2 pressure regulator from kegkits.com
Does anybody here know much about this regulator? I've never dealt with any regulators so I don't know how much the quality can really vary. The one I listed is about $25 less than most others I've seen.
If it's questionable, I may start with a single pressure regulator and then add on a second later (or maybe just suck it up and buy a better one). I understand the reasons for having two (pour while carb and different pouring pressures), but I don't know how much that would really effect me at this point.
Anyway, please let me know if I'm missing anything and I appreciate any other advice you have to offer. I'm really looking forward to getting this going.
Jeremy
I was looking into conversion kits, but all the threads I read advocate spending money on the good stuff (Perlicks, all SS, etc.) up front. I'd really appreciate it if you could look over my equipment list and answer a few questions I have about specific items.
I'm picking up the Sanyo SR-4912M from Best Buy today. I'll also be going with a 5# CO2 tank and four ball lock kegs (two in the fridge, two ready to go).
Rest of the parts, followed by a question or two:
- 2 faucet, brushed SS tower from ACU Metal Fab
- Perlick all SS faucets
- SS elbow shanks from micromatic.com (seems to be the only one carrying these)
- 1/4" gas line, 3/16" beer line
- 1/4" flare to barbed fittings & hose clamps
- 1/4" threaded gas & liquid disconnects
- 2 pressure regulator from kegkits.com
Does anybody here know much about this regulator? I've never dealt with any regulators so I don't know how much the quality can really vary. The one I listed is about $25 less than most others I've seen.
If it's questionable, I may start with a single pressure regulator and then add on a second later (or maybe just suck it up and buy a better one). I understand the reasons for having two (pour while carb and different pouring pressures), but I don't know how much that would really effect me at this point.
Anyway, please let me know if I'm missing anything and I appreciate any other advice you have to offer. I'm really looking forward to getting this going.
Jeremy