So, I have two chugger pumps and both worked very well up until a couple of weeks ago when one started locking up. By locking up, I mean the impellor will just freeze after about 20 minutes. The motor still runs but the pump quits.
Mike at chugger says it's because I need full port 1/2 ID quick disconnects because the 3/8 qd's cause cavitations which makes the pump impellor spin out against the pump head and lock up.
Anyone else have this issue? My other pump (chugger ) doesn't do this and the QD's are the same throughout the entire system.
Anyone know where to get full ported 1/2 QD's?
Mike at chugger says it's because I need full port 1/2 ID quick disconnects because the 3/8 qd's cause cavitations which makes the pump impellor spin out against the pump head and lock up.
Anyone else have this issue? My other pump (chugger ) doesn't do this and the QD's are the same throughout the entire system.
Anyone know where to get full ported 1/2 QD's?