Learn from my mistakes Vol. 1

Apparently I need to add a few things to my brew day check list.

1. Check mill gap - changed on its own, the only thing I can think of is that the cold weather in my garage caused some shrinkage

2. Charge drill battery and the backup - hand cranking grain is no fun

3. Rack beer in fermenter before - I was dealing with above issues and didn't notice about a half a pint spill over the top of the keg and onto the floor

Hopefully this will help others

Did your crush get too course?

What was your recipe and did you get near your O.G.?

It turned out fine in the end. Basically no crush at all. It looked like I just dumped the grain into another bucket. I readjusted it and ran it again but this time by hand.