brewprint
Well-Known Member
- Joined
- May 7, 2014
- Messages
- 1,616
- Reaction score
- 169
I've taken the step to get my water tested finally. I'm trying to figure out exactly what I need to do to get the proper pH doing full volume mashes.
I put the report into the bru'n water and it says it's unbalanced. I'm lost here.
Also, what is the best way to figure out what I need to do to get my water corrected?
pH 8.1
Total Dissolved Solids (TDS) Est, ppm 985
Electrical Conductivity, mmho/cm 1.64
Cations / Anions, me/L 15.6 / 16.3
Sodium, Na 332
Potassium, K 1
Calcium, Ca 13
Magnesium, Mg 6
Total Hardness, CaCO3 58
Nitrate, NO3-N < 0.1 (SAFE)
Sulfate, SO4-S 159
Chloride, Cl 19
Carbonate, CO3 < 1.0
Bicarbonate, HCO3 354
Total Alkalinity, CaCO3 294
Total Phosphorus, P < 0.01
Total Iron, Fe < 0.01
I put the report into the bru'n water and it says it's unbalanced. I'm lost here.
Also, what is the best way to figure out what I need to do to get my water corrected?
pH 8.1
Total Dissolved Solids (TDS) Est, ppm 985
Electrical Conductivity, mmho/cm 1.64
Cations / Anions, me/L 15.6 / 16.3
Sodium, Na 332
Potassium, K 1
Calcium, Ca 13
Magnesium, Mg 6
Total Hardness, CaCO3 58
Nitrate, NO3-N < 0.1 (SAFE)
Sulfate, SO4-S 159
Chloride, Cl 19
Carbonate, CO3 < 1.0
Bicarbonate, HCO3 354
Total Alkalinity, CaCO3 294
Total Phosphorus, P < 0.01
Total Iron, Fe < 0.01