Nitsua
Active Member
I have hard water and was told that the easiest way to soften it is to cut it 50/50 with Distilled water.
I have both ProMash & BeerSmith
BeerSmith allows me to add multiple waters, but can I not see the specific mineral measurements after the combination?
I have yet to figure out how to add two diff waters in ProMash. If I can get the specific mineral measurements from BeerSmith I can create a 50/50 water profile in ProMash.
Is this possible?
I am I being totally OCD?
Thanks
I have both ProMash & BeerSmith
BeerSmith allows me to add multiple waters, but can I not see the specific mineral measurements after the combination?
I have yet to figure out how to add two diff waters in ProMash. If I can get the specific mineral measurements from BeerSmith I can create a 50/50 water profile in ProMash.
Is this possible?
I am I being totally OCD?
Thanks