TravelingBrewer22
Well-Known Member
I would love some advice here guys. Recently upgraded to some keggles and looking to begin picking up valves, QD's, and other fittings for when I'm done drilling holes and cutting off tops. My situation is this, a while back I picked up about 30' of 3/4" ID x 1.25" OD silicone tubing (I got a great deal) so then I got a few 3/4" camlocks from ProFlow to hook up my old kettle and MLT. Now that I've got these Kegs I'm not sure if I should buy 3/4" ball valves and more QD camlocks, or eat the cost of the 3/4" tubing and go with the more traditional 1/2" fitting all the way around and pick up 1/2" tubing instead.
Hope that made sense. The reason I'm asking is for future reference. I can get all 3/4" stuff now and it will work with my rig and no worries. But if, in the future I want to upgrade or sell will it be a PITA to sell/trade equipments with 3/4" fittings and tubing?
Thanks for the input.
Hope that made sense. The reason I'm asking is for future reference. I can get all 3/4" stuff now and it will work with my rig and no worries. But if, in the future I want to upgrade or sell will it be a PITA to sell/trade equipments with 3/4" fittings and tubing?
Thanks for the input.