mhermetz
Well-Known Member
For those of you that remember me posting the **** disturbing GFCI post and the Farking Welder...here is the Kettle all set to go for my Brew day tomorrow.
All previous problems I mentioned about the bottom not heating up because the elements were too high (Damn Welder!) are now debunked. It will eventually circulate the water... however, I will say it was a lot faster if I stirred the water myself.
We also plan on making the 2 wires disconnect from the kettle but for the sake of time and my brew day tomorrow, my dad wired it straight to the Kettle.
Here's some pics!
Position of first element...Farking Welder..
Not sure what Happened to sound... but here's it working:
Video is still processing on you tube apparently.... it should work soon.
All previous problems I mentioned about the bottom not heating up because the elements were too high (Damn Welder!) are now debunked. It will eventually circulate the water... however, I will say it was a lot faster if I stirred the water myself.
We also plan on making the 2 wires disconnect from the kettle but for the sake of time and my brew day tomorrow, my dad wired it straight to the Kettle.
Here's some pics!
Position of first element...Farking Welder..
Not sure what Happened to sound... but here's it working:
Video is still processing on you tube apparently.... it should work soon.
Last edited by a moderator: