justinm
Active Member
I am just starting construction of my automated brewing system and purchased lab jack usb controller for controlling temperatures. However, I could not find any open source brewing specific software for the controller.
This means I would need to write my own software through DAQ factory, labview, or some other alternatives. This sounds fun but also really time consuming and possibly limiting with law school schedules.
I know a couple people on the boards like jrm16311 and deep six have written software for the labjack. I was wondering if there was any advise on where to start with the software development or if anyone had software they were willing to part with or sell. Ideally, I would like to customize the software to my rig, but would love to not have to reinvent the wheel if possible.
Thanks.
Justin Miller
www.symposiumbrewery.com
This means I would need to write my own software through DAQ factory, labview, or some other alternatives. This sounds fun but also really time consuming and possibly limiting with law school schedules.
I know a couple people on the boards like jrm16311 and deep six have written software for the labjack. I was wondering if there was any advise on where to start with the software development or if anyone had software they were willing to part with or sell. Ideally, I would like to customize the software to my rig, but would love to not have to reinvent the wheel if possible.
Thanks.
Justin Miller
www.symposiumbrewery.com