Memorex88
Well-Known Member
Converting a cooler to a mash tun - Home Brewing Wiki
I just built the Rectangular manifold and I am about to make the slots.
My question is, are these slots "thin enough"? How important is the thickness of the slits?
I have a choice of using....
(from thinnest to thickest)
1. Hacksaw (physically hardest to do but thin)
2. Dremel with cutting disk
3. Grinder with 4" X .808" Diamond Blade (by far the easiest to do)
I imagine the thinner the better but what's the experience on the forum?
I just built the Rectangular manifold and I am about to make the slots.
My question is, are these slots "thin enough"? How important is the thickness of the slits?
I have a choice of using....
(from thinnest to thickest)
1. Hacksaw (physically hardest to do but thin)
2. Dremel with cutting disk
3. Grinder with 4" X .808" Diamond Blade (by far the easiest to do)
I imagine the thinner the better but what's the experience on the forum?