Bigscience
Well-Known Member
I’m curious as to what setups people with a HERMS system use as far as materials, design, performance and their overall satisfaction. I put together a few questions below as a way to gather the info. After the results are all in, I was going to summarize. Thanks in advance for your feedback.
Coil Material (SS, Copper, Other) -
Tube Length -
Tube Diameter -
Coil Placement (HLT, MT, Kettle, Other) –
Chamber Fluid Volume (eg. HLT with 7 gal) -
Heating Method (Electric, Gas) -
Do You Stir Chamber Fluid (Yes/No) -
Chamber Temp Setting (Contestant eg 170F, Mash Temp, Mash +5… -
Achievable Ramp (Deg/min) -
Used for Step Mash -
Flow Rate -
Mash Thickness –
Would you build it this way again or what would you change?
Coil Material (SS, Copper, Other) -
Tube Length -
Tube Diameter -
Coil Placement (HLT, MT, Kettle, Other) –
Chamber Fluid Volume (eg. HLT with 7 gal) -
Heating Method (Electric, Gas) -
Do You Stir Chamber Fluid (Yes/No) -
Chamber Temp Setting (Contestant eg 170F, Mash Temp, Mash +5… -
Achievable Ramp (Deg/min) -
Used for Step Mash -
Flow Rate -
Mash Thickness –
Would you build it this way again or what would you change?