from propane cylinder to manifold

Thread starter krazykraut
Start date Jan 31, 2011

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

krazykraut

Member

Jan 31, 2011

So my new single tier stand is almost complete, all in gleaming stainless. I had a professional build the gas beam similar to the Brutus, with 1/2 NPT fittings for all three burners. Tested leakproof. I'm going the low pressure route with banjo burners, standing pilots and BrewTroller controlled Honeywell gas valves. While the electronics are easy for me, I'm not too comfortable with the gas side, and I'll have a professional go over it before test firing. I just wanted to get the ordering started for the gas fittings, build it, and have it ready to be inspected.

Does one of you guys have a list of the items to go from the standard 20lb. cylinder to the 1/2 in FNPT on the gas manifold? I already have a Marshall 299-00 two stage regulator, but need hoses, bushings etc. Any suggestions/links?

Thanks, and pics of the rig will follow.

- Krazykraut