so i acquired a beautiful ss sam keg yesterday and have a buddy who is a professional welder. my question is where you guys reccomend buying the bungs to weld in and at what heights do they get welded in?
i only wanna have a spigot at the bottom that i can screw a screen into and one a lil higher up to have a thermometer in.
i plan to mash in it with my same bayou burner i use for 5 gallon batches. batch sparge in it, (run the wort out into my two pots i use for 5 gallon batches) clean it out quickly, and then do the boil in it. After the boil i would just split the wort into two carboys or buckets to ferment, and later into two cornys.
suggestions?
i only wanna have a spigot at the bottom that i can screw a screen into and one a lil higher up to have a thermometer in.
i plan to mash in it with my same bayou burner i use for 5 gallon batches. batch sparge in it, (run the wort out into my two pots i use for 5 gallon batches) clean it out quickly, and then do the boil in it. After the boil i would just split the wort into two carboys or buckets to ferment, and later into two cornys.
suggestions?