brauhausjoe
Well-Known Member
Now that you have cut the top off your keg, how do you re-use it for a lid? I have welded stainless pieces on the rim so it does not fall in. But how do you plug the center hole? I wanted to plug it with a wood plug, but I thing it would swell up and go 'bad' after a few uses. The bottom is what I am worried about. Is there something I could use to seal the hole from the wood? I really dont want to weld it shut.
Here is the hole I am talking about (I am sure you have all seen it before)
Here is the plug:
Here is the issue. How would you seal it?
Thanks!
Here is the hole I am talking about (I am sure you have all seen it before)
Here is the plug:
Here is the issue. How would you seal it?
Thanks!