The J2 Alarm which is set for Low Temperature warning has a real quiet but noticeable continuous pulsing buzz and the LED lights up just a little. Like some kind of bleed-over. When it is triggered by the Alarm settings it works as it is suppose to. Everything works as it is suppose to except this low buzzing noise. I traded the buzzer out with another, same issue. Double check all grounds.
outY setting is set to 2. J1 alarm, J2 alarm, SSR PID controlled
also set outY to 3 which makes SSR on/off
Any Ideas?
I sent mail to Auber Instruments also.
outY setting is set to 2. J1 alarm, J2 alarm, SSR PID controlled
also set outY to 3 which makes SSR on/off
Any Ideas?
I sent mail to Auber Instruments also.