I need to drill holes in my key for a spigot.
Any ideas on the best way to achieve this?
Any ideas on the best way to achieve this?
tnlandsailor said:I've done this a couple of times for weldless fittings. The hole saw works very well. Use a relatively low speed and high contact force and lots of lube. Should take less than a minute of drill time total.
orfy said:I need to drill holes in my key for a spigot.
Any ideas on the best way to achieve this?
akula169 said:Not sure if they are at your local, but I just picked a nice set of 4 different sized step bits at Costco for $40 - tremendous deal.
Enter your email address to join: