Hello.
I have Auber SYL-2352 which I use in manual mode when boiling with my 5500W element. I turn it down to 70% but it seems that the controller is working like in binary mode, turning the element on for 30 seconds and off for 10 seconds and then back on again. I would think the behavior should be more that the controller is constant in 70% power. When I try it in 95% in manual mode in behaves the same but is longer on and shorter off. It is not due to overheating because I'm cooling the element.
I'm wondering if it is some setting that I have changed unknowingly or is it some deeper problem?
Any ideas?
Johann
I have Auber SYL-2352 which I use in manual mode when boiling with my 5500W element. I turn it down to 70% but it seems that the controller is working like in binary mode, turning the element on for 30 seconds and off for 10 seconds and then back on again. I would think the behavior should be more that the controller is constant in 70% power. When I try it in 95% in manual mode in behaves the same but is longer on and shorter off. It is not due to overheating because I'm cooling the element.
I'm wondering if it is some setting that I have changed unknowingly or is it some deeper problem?
Any ideas?
Johann