I ordered a used Ranco unit ETC111000-000 off the bay, the unit came from a reputable seller who has sold a number of the same controller. I wired it according to these instructions: http://powersbrewery.home.comcast.net/~powersbrewery/Rancoetcdoc.pdf
With the help of this step by step process (completed for single stage) using this thread:
https://www.homebrewtalk.com/f51/how-ranco-two-stage-etc-wiring-instructions-145370/
I checked to make sure all of the wires are tight and secure to each other. I plugged it in and nothing, tried the set button a few times, nothing.
Any suggestions?
Is it possible the unit is shot?
I can't post an attachment to show a pic but not sure it would help because it is a little difficult to show how the wires are connected and sourced.
With the help of this step by step process (completed for single stage) using this thread:
https://www.homebrewtalk.com/f51/how-ranco-two-stage-etc-wiring-instructions-145370/
I checked to make sure all of the wires are tight and secure to each other. I plugged it in and nothing, tried the set button a few times, nothing.
Any suggestions?
Is it possible the unit is shot?
I can't post an attachment to show a pic but not sure it would help because it is a little difficult to show how the wires are connected and sourced.