flanneltrees804
Well-Known Member
My friend and I built the Kal control panel, triple checked everything to make sure it was wired properly, turned it on and it shorted out because the adjustable dc power supply touched the back plate. When I turned the panel on the blue power light flashed and the main power relay turned on and off a few times until I turned the whole panel off. The flashing and relay engaged 3 times in about 2 seconds. We also had to replace the 7a fuse cause it got toasted. We unhooked the volt meter and when we turned the panel back on nothing happened. Any ideas as to what might be happening? I know it's not much info to go on but we poked around with a volt meter but don't really know much about where there should and should not be power. I'll take some readings and pictures when I get a chance but in the mean time I wondered if anyone could tell me if I fried another part and what that might be. Thanks!