So I got the "Weld less fitting to convert a keg, kettle, or pot." from great bargains, and it has a 1/2" Stainless nipple.
http://www.greatbargain.net/order/shop1.html -- second one on the page.
What size step bit do I need? I measured with a ruler and it looks like I'd need 3/4" hole to fit this nipple through...1/2" must be the inner diameter??
I'd like to drill my brewpot today or tomorrow so I can finally start going All grain.
(yes, I'm mechanically retarded)
http://www.greatbargain.net/order/shop1.html -- second one on the page.
What size step bit do I need? I measured with a ruler and it looks like I'd need 3/4" hole to fit this nipple through...1/2" must be the inner diameter??
I'd like to drill my brewpot today or tomorrow so I can finally start going All grain.
(yes, I'm mechanically retarded)