Just switched to BIAB and on the last two brews I've managed to get only 4.5 gallons into the fermenter. I've been pretty close on my numbers and had good efficiency so I have good beer, just not as much.
When extract brewing I started with 6.5 gallons of water and had just over 5 after an hour boil. I figured the boil rate would be the same but apparently it is not. Any ideas? Should I simply adjust to have more wort at the start of the boil?
When extract brewing I started with 6.5 gallons of water and had just over 5 after an hour boil. I figured the boil rate would be the same but apparently it is not. Any ideas? Should I simply adjust to have more wort at the start of the boil?