robertvrabel
Well-Known Member
Siphon: http://www.brew-magic.com/ketl_acc_unisiphon.html
Faslse Bottom (with hole): http://www.brew-magic.com/ketl_acc_falsebtm.html
My Keggle: http://www.homebrewing.org/155-Homebrew-Kettle-With-One-Weld-Half-Barrel_p_1004.html
So for some reason the siphon will not line up with the false bottom hole properly, about 1/2" off (being too long). I screwed the siphon all the way in as far as I can go, seems to stick out a bit though.
What are my options here? I'm thinking of possibly get a hold of a welder to see if they can trim down the siphon piece by a 1/2" so it lines up properly. Or possibly return the false bottom and get one without a hole, then drill the hole myself in the proper spot I need.
Any suggestions, or has anyone ran into this problem?
Faslse Bottom (with hole): http://www.brew-magic.com/ketl_acc_falsebtm.html
My Keggle: http://www.homebrewing.org/155-Homebrew-Kettle-With-One-Weld-Half-Barrel_p_1004.html
So for some reason the siphon will not line up with the false bottom hole properly, about 1/2" off (being too long). I screwed the siphon all the way in as far as I can go, seems to stick out a bit though.
What are my options here? I'm thinking of possibly get a hold of a welder to see if they can trim down the siphon piece by a 1/2" so it lines up properly. Or possibly return the false bottom and get one without a hole, then drill the hole myself in the proper spot I need.
Any suggestions, or has anyone ran into this problem?