angolajones
Member
Tried to hook up my second keg and it is a no go. I have had the CO2 going for a week and wanted to hook up the faucet. I was unable to get the disconnect to fit. It is as if the Keg Post is too big. I thought that maybe I had switched the in and out and the disconnect wouldn't fit on the other post either. I then hooked this disconnect up to my other corny and it works.
Are there different sized posts between these kegs? They are both ball locks. The first keg has a different way to take off the posts. A wrench will work with it. The second one I am having problems with has a special tool which was sent with the keg. But, the wrench they sent was way too big for this one. Don't know if that is important or not.
After looking again, is it possible that whoever reconditioned my kegs put in two gas lines instead of one in and one out?
I'm going crazy trying to get this to work.
Jonesy
Are there different sized posts between these kegs? They are both ball locks. The first keg has a different way to take off the posts. A wrench will work with it. The second one I am having problems with has a special tool which was sent with the keg. But, the wrench they sent was way too big for this one. Don't know if that is important or not.
After looking again, is it possible that whoever reconditioned my kegs put in two gas lines instead of one in and one out?
I'm going crazy trying to get this to work.
Jonesy