kosmokramer
Well-Known Member
So i picked up a hobart 135 machine to weld up my brewstand from craigslist for 250. I got it home closed my eyes and ran a half inch bead. It cam out fine and the machine sounded great and steady. I cut all my steel today and went to tack some pieves of scrap to adjust wire feed and voltage when the feed stopped. I thought it arced to the tip and was stuck but that was not the case.... Bottom line, no tip on the gun, tension wheel released and flipped back and the drive wheel still isnt spinning. I did not exceed duty cycle, all wires appear to be makin contact, drive wheel just wont spin... any ideas???!!!!! I took a vacation day tomarrow to weld this so itll suck if there is a major issue