DeadGuyNick
Well-Known Member
When I did a dry fitting of my kegerator insides, everything seemed fine. But I forgot to check clearance with the beer lines attached to the shanks! :smack:
I drilled new holes higher up to clear my kegs, but now there are two holes I need to cover. The front is all black chalkboard paint, and I don't like stickers, really. I wanna keep it a bit classy. Any ideas? Maybe a small chrome plate would look cool?
Also, would stuffing the holes with newspaper and foil taping the inside be sufficient for insulation, or should I buy some foam or caulk or something?
I drilled new holes higher up to clear my kegs, but now there are two holes I need to cover. The front is all black chalkboard paint, and I don't like stickers, really. I wanna keep it a bit classy. Any ideas? Maybe a small chrome plate would look cool?
Also, would stuffing the holes with newspaper and foil taping the inside be sufficient for insulation, or should I buy some foam or caulk or something?