Chap
Well-Known Member
Sorry for the NOOB question, but in everything I read about force carbing and sealing the keg it talks about bleeding off pressure. Is this done by turning off the gas and removing the "in" line and bleeding from the post (no relief valve on my corny's)? Or do you turn off the gas and use the relief valve on the regulator?
can you also verify these procedures:
- rack to the sanitized keg
- pressure to 30 psi and roll or shake the keg for a few minutes
- release the pressure
- repeat the process twice more
- store the keg t 30 psi over night
- reduce to desired psi (12 in my case) and drink
Thanks
can you also verify these procedures:
- rack to the sanitized keg
- pressure to 30 psi and roll or shake the keg for a few minutes
- release the pressure
- repeat the process twice more
- store the keg t 30 psi over night
- reduce to desired psi (12 in my case) and drink
Thanks