So I am about ready to paint my brew stand. Single-tier with 1.5" mild steel. I am planning on using some of that 2000F header paint for the steel around the burners. However I would like to use a bright yellow 500F engine paint for the main part of the stand. I know that will probably not work at all around the burners. So I am trying to figure out what the temp of the steel is at is goes down the stand.
Here's the blueprint. If anything I would do the 2000F stuff for the whole top. But on the 6 pieces pieces coming down could I use the 500F paint as soon as it clears the 1/5" of the top piece?
Also what about primer? I don't think they make a 2000F primer. So would I not use anything for the top piece? What the 500F paint, use 500F primer for that? Thanks all.
Here's the blueprint. If anything I would do the 2000F stuff for the whole top. But on the 6 pieces pieces coming down could I use the 500F paint as soon as it clears the 1/5" of the top piece?
Also what about primer? I don't think they make a 2000F primer. So would I not use anything for the top piece? What the 500F paint, use 500F primer for that? Thanks all.