Well not the most glamorous of first posts but I am having a devil of a time opening my recently acquired keg. I have searched the forums as well as Google but can't seem to find any instructions for a keg quite like mine. I have been following this one as my reference
Everything seems pretty standard except there was no retaining spring, and seemingly no place where one should be. There is no "female tab" on the actual keg either. (The place where you would put the screwdriver to get the spring out" All I did was hit the valve tab with my screwdriver and hammer a few times, and about 4 or 5 FULL rotations later the valve seems to be unscrewed all the way, but It still wont come out. I then found this video which shows a different type of mechanism using a clockwise method of removal..but that doesnt seem to work either
I am so confused.. If it helps.. it is a Miller Brewing Keg.
thanks
mike
Everything seems pretty standard except there was no retaining spring, and seemingly no place where one should be. There is no "female tab" on the actual keg either. (The place where you would put the screwdriver to get the spring out" All I did was hit the valve tab with my screwdriver and hammer a few times, and about 4 or 5 FULL rotations later the valve seems to be unscrewed all the way, but It still wont come out. I then found this video which shows a different type of mechanism using a clockwise method of removal..but that doesnt seem to work either
I am so confused.. If it helps.. it is a Miller Brewing Keg.
thanks
mike
Last edited by a moderator: