Jared311
Well-Known Member
So I purchased this screw-in camco heating element:
http://www.camco.net/Menu.cfm?SupCategoryId=10200&SubCategoryId=233&ProductId=2344
The problem is that I can't get it to fit though my 1" coupling because of all the bends in the element. I was wondering if anyone else ran into this problem and how they got around it. I was thinking about just cutting my coupling in half because it is 1.75" long and maybe that would give me a little more room to work with.
http://www.camco.net/Menu.cfm?SupCategoryId=10200&SubCategoryId=233&ProductId=2344
The problem is that I can't get it to fit though my 1" coupling because of all the bends in the element. I was wondering if anyone else ran into this problem and how they got around it. I was thinking about just cutting my coupling in half because it is 1.75" long and maybe that would give me a little more room to work with.